Tinplate is a steel sheet that has been dipped in molten tin. The steel gives the piece its stiffness and takes the fold. The tin keeps the air off the steel and lets solder wet the joint, which bare steel will not do without a fight.
The coat goes at the three places a pail is handled. The underside of the rim, where it knocks the edge of a churn. The bottom, where it is dragged across concrete. And a band inside at about two thirds height, where a brush turns at the same spot every morning for fifteen years.
Everywhere else the tin is still doing its job. That is why re-tinning is worth the money: the body, the seams and the wired rim are sound, and only the skin has gone.
Nothing here was replaced. The bodies are the ones that went out, with a new coat and, where the rim had gone oval, a new wire rolled in.
Both rims had gone oval under a loaded hook. New 2.5 mm wire rolled in, bottoms unhooked, re-dipped, bottoms sweated back. €58 each.
The spout joint had weeped for a decade and stained the body. Spout off, body stripped, re-dipped, spout sweated on with the lead-free bar. €44.
Grooved seam sound, the sheet eaten thin at the bottom edge by condensate. Bottom 90 mm cut off, a new collar folded on. €29.
Leave the piece at the gate on a Tuesday or put it in the post with your name inside it. Hiltrud writes back with the work it wants and the price of it before a single seam is opened.